Concrete mixing plant accessories debugging and setting

After concrete mixing plant installed in order to ensure that the batch plant can run normally, debugging and setting the relative concrete batching plant accessories are needed. Set up and commissioning normal, the batch plant can work. How to set up the concrete mixing plant accessories  and debugging, the following detailed introduce to everyone.
1. The metrology calibration of electronic balance
Before the scale, shall, first of all, to dismantle the balance between the bucket and rack fixed bolt, the sensor in the free stress state. Then, according to the batching control instrument operation instruction handbook "setting parameters of each scale. Press with remove code of each scale range for calibration. After the calibration, overload experimental check weighing, measurement is accurate.
2. The idle running
Through to the main power supply, close the main switch, the power supply with a key to the open position, start the computer, observation instrument, computer display is correct.
For each part of the inspection station, make sure everything is normal, can operate, press the starting button blender. Starting a blender. Open air compressor, make the system pressure is 0.7 MPa.
3. The discharging time Settings
At the same time press the "A" + "B" + "host close" button to remove previously set the time.
At the same time press the "A" + "F spare Ii, '+" host to open the door "button, press the button of the time is discharging time.
Note: if concrete batching plant accessories equipped with ajar door, the total discharge time 2 ajar door 10s 10 set of discharging time, when fully automatic, meet after full/half signal, discharging time timing.
Above is the setting method of concrete batching plant, and debugging method, after the installation is complete, must according to the method of debugging test, such not only can have a good understanding about the structure of concrete mixing station, also can be a very good avoid fault and problems, also can some troubleshooting and solve in time.