Portable concrete batching plant project should be checked regularly pay attention to what ?

Concrete mixers per week should check:

Check the small concrete batching plant rope wear and coated with a little oil in their show , wire rope wear to a certain extent , it should be replaced.

Check the gearbox oil level , fuel pump , check the lubrication situation , to the hopper roller bearings and pulley bearings add oil.

Water supply device should be kept clean to prevent blockage of the suction valve inspection cleaning. Check the limit switch arm is loose, if loose should be necessary adjustments.

Check the ready mixed concrete mixing plant blade attachment bolts , the support arm connecting bolts are loose discretion to adjust the blade clearance with the cylinder walls 5mm maximum gap and make the necessary tighten.

Check the electrical box concrete mixer contactor contact situations .

Twist open the blockage , check the shaft seal , make the necessary adjustments to repair and replacement.

Concrete mixer on a regular basis should check:

On the hoist brake check and make appropriate adjustments.

The pump , throttle to check whether there is water leakage.

Split Lubricate gear check and adjust the belt tension .

Check the concrete mixer blade, liner wear, and replace as appropriate .