How to care concrete batching plant reducer?

 

1, lubricants, gear lubricants used in extreme pressure using GB/T5903-1986 extreme pressure gear oil N220 or N320, when the ambient temperature is ≤ 30 ℃ when using the N220, when the ambient temperature is above 30 ℃, u

2, gear lubrication system uses a normally open cooling method using immersion oil circulation lubrication lubrication system on the roller press lubrication system must be activated prior to confirmation of the lubrication points with oil supply after 3-5 minutes before turning gear the initial installation of the gear unit in the fuel line to the oil standard required after plate moving speed reducer gearbox input shaft to ensure that within the bearing with oil lubrication. 

3 monthly check the motor and reducer between the bolts are tightened, weekly inspection and installation reducer coupling between the base bolts are tightened . 

4, monthly cleaning breathable cap with kerosene and petrol stations once the filter, clear debris inside the filter ; filter cleaning gear unit must not operate in the circumstances. 

5,concrete batching mixing plant in the early running gear should be replaced every 300 hours after the lubricant oil with low viscosity oil before cleaning inside the stolen goods, after every 12 months for an oil, for continuous operation day and night occasions every six months for an oil . In the newly installed oil before use light oil will gear rinse. 4, once a month lubricant cleanliness, dirty oil discovery, deterioration should be replaced, not be subject to time limits.

 

Pre: Problem in the working process of batching plant
Next: HZS50 concrete batching plant’s Working Process